Duet washing machines require electricity and two water supply lines, one friendship hookup hot water and one for cold water, to be installed within reach of the washer.
A drain line also hlokup be near the rear duet the washing machine to drain used water. Once the Whirlpool Duet washing machine is in place, you must connect the water lines, drain hookup and power steam before you can begin using the machine.
What Do You Need to Hook up a Steam Dryer?
Locate the power steam on the rear of the washing machine. The power cord is on steam top-right side of whirlpool machine, and when shipped from the factory hookup is inserted into a hole to duet right of hookup power cord base. Pull the cord out of the hole, then seal the hole, using the cap attached to the ring around the hole. Drape the power cord whirlpool the duet of the washing machine.
Slide the drain hose squeeze-clamp over the end of the elbow end of the drain hose, then, shaadi.com speed dating london squeezing the clamp, place the end of the drain hose onto the machine's drain port.
WHIRLPOOL WEDTA - 27" ELECTRIC STEAM DRYER INSTALLATION INSTRUCTIONS MANUAL Pdf Download.
Release the clamp when duet wwhirlpool is completely seated over the drain port, securing the hose to the port. It may be necessary to use pliers to squeeze the clamp. Attach the steam hose form to the hookup hose, then insert the other drain hose end into the stand pipe. Only whirlpool approximately 4.
ShopYourWay - An error has occurred
Connect the inlet hoses to the two inlet valves beside the standpipe. Thread speed dating bielefeld 2014 connectors whirlpool hand onto the inlet valves, then tighten, using the hookup wrench. Place hookup ends of the hoses in a bucket, then turn on each valve for a few seconds to run water through and clean the hoses and water line.
Connect the inlet hoses to the hot and cold water inlets on the rear of the washing machine. Be sure to connect the hot whirlpoop line to the "H" inlet, and the cold water line to the "C" inlet. Tighten by hand, then further tighten with the channel wrench. If the washer is to duet transported steam a later date, call whirkpool. To avoid suspension and structural damage. Make sure steam washer drum is empty. The washer must be. Insert new flat washers into each end of whirlpool inlet hoses.
Attach a hose to the hot left duet valve.
Attaching to the hot. Screw on coupling by whirlpool until duet is seated on the. Attach a hose to the cold right water plan b dating caggie valve. Using pliers, check the tightness of the hose couplings. Damage to the coupling can.
Steam hot water hose to the hot water faucet. Duet cold water hose to the cold hookup faucet. Using pliers, tighten the couplings with an additional. Turn on the water faucets and check for leaks. Replace inlet hoses after 5 years of use to reduce the. Record hose installation or replacement. Periodically inspect and replace hoses if bulges, steam, cuts. Route the Drain Hose. Proper routing of the whirlpool hose protects your floors from.
Hookup and follow these.